Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Cabin Temperature Sensor / Switch: Service and Repair
Removal
1. Disconnect the negative battery cable.
2. Remove the automatic temperature control assembly.
3. Remove the screws securing the in-car temperature sensor.
4. Disconnect the electrical connector and remove the sponge cover.
5. Remove the in-car temperature sensor from the controller.
Installation
1. Install the in-car temperature sensor into the controller.
2. Install the sponge cover and connect the electrical connector.
3. Install the in-car sensor retaining screws and tighten.
4. Install the automatic temperature control assembly.
5. Connect the battery negative cable.
