Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Brake Light Switch: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the connector from the stoplamp switch.
3. Rotate the switch and remove it from the brake pedal bracket.
Installation Procedure
1. Insert the stoplamp switch into the brake pedal bracket and rotate the switch to lock it.
2. Connect the electrical connector to the stoplamp switch.
3. Press the brake pedal and pull the switch plunger to its maximum setting to adjust the switch.
4. Release the plunger and pull up on the pedal.
5. Connect the negative battery cable.
