Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
10. After all the air has been removed at the forward connection(s), bleed the master cylinder at the rear (cowl) connection(s) in the same manner as
with the front connections.
Important: For vehicles equipped with a non-antilock braking system, the bleeding sequence is as follows: right rear, left rear, left front and right
front. For ABS vehicles, refer to Antilock Brake System for the correct sequence and bleeding procedure.
11. Attach a transparent tube over the valve. Allow the tube to hang submerged in brake fluid in a transparent container.
12. Slowly push and hold the brake pedal one time.5:
13. Remove the bleeder valve dust cover and loosen the bleeder screw to purge the air from the cylinder.
14. Slowly release the brake pedal. Wait 15 seconds before proceeding with the next step.
Important: Rapid pumping of the brake pedal pushes the master cylinder secondary piston down the bore in a manner that makes it difficult to
bleed the system.
15. Repeat the sequence, including the 15-second wait, until all the air is removed. It may be necessary to repeat the sequence 10 or more times to
