Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Engine Control Module: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the passenger side kick panel. Refer to Interior Trim.
3. Disconnect the powertrain control module (PCM)/engine control module (ECM) retaining clip from the PCM/ECM mounting base.
4. Remove the retaining clip lower end from the mounting base.
5. Remove the PCM/ECM from the mounting base.
6. Disconnect the PCM/ECM connectors from the PCM/ECM.
Installation Procedure
