Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Ignition Lock: Service and Repair
IGNITION LOCK CYLINDER AND SWITCH
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the lower steering column cover panel by removing the screws.
3. Disconnect the electrical connector for the immobilizer detection coil, if equipped.
4. With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring with a 2.5 mm
alien wrench or other suitable tool, and pulling the lock cylinder out of the switch cylinder housing.
5. Remove the ignition switch retaining screw.
6. Disconnect the wiring and remove the ignition switch.
