Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
1. Place the starter assembly in position using an assistant to prop up the starter. This will aid in screwing in the upper stud with the weld nut.
2. Install the starter mounting bolts.
Tighten
Tighten the starter-to-engine block mounting bolt to 45 N.m (33 lb-ft) and the starter-to-transaxle mounting bolt to 50 N.m (37 lb-ft).
3. Position the starter electrical wire on the solenoid terminal and the ground wire on the lower stud.
4. Install the starter solenoid nuts and the ground wire nut.
Tighten
Tighten the starter solenoid terminal-to-battery cable terminal nut to 7 N.m (62 lb-in), and the starter solenoid terminal-to-ignition solenoid
terminal nut to 6 N.m (53 lb-in). Tighten the starter lower mounting stud ground wire nut to Nm (lb-in).
