Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
IMPORTANT: A means for adjusting the pinion clearance is not provided on the starter motor. If the clearance does not fall within the limits,
check for improper installation and replace all of the worn parts.
32. Push the pinion back as far as possible to take up any movement, and check the clearance with a feeler gauge. The clearance should be 0.25 to
3.56 mm (0.01 to 0.14 inch).
Assembly
1. Clean all of the starter motor parts. Do not use grease-dissolving solvents for cleaning the armature and the field coils.
2. Lubricate the gears with lubricant. (Begin at Step 7 if proceeding with just the reassembly of the solenoid.)
3. If full disassembly of the starter and the solenoid was performed, begin reassembly by placing the gear support on the driveshaft assembly.
4. Install the drive and the pinion stop on the driveshaft.
