Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
2. Install the dash seal retaining ring with the nuts.
Tighten the dash seal retaining ring nuts to 9 Nm (80 inch lbs.).
Important: When attaching the upper universal joint, the steering wheel must be placed in the straight-ahead position with the spokes pointing down.
3. Attach the upper universal joint of the intermediate shaft onto the steering column.
4. Install the pinch bolt into the upper universal joint on the intermediate shaft and tighten the bolt.
Tighten the upper intermediate shaft pinch bolt to 22 Nm (16 ft. lbs.).
Important: When attaching the lower universal joint, the marks on the intermediate shaft and on the stub shaft should line up.
5. Attach the lower universal joint of the intermediate shaft onto the steering gear stub shaft.
Important: When installing the lower intermediate shaft pinch bolt, make sure the bolt goes through the universal joint on the side of the stub shaft
with the notch. If you have trouble seating the universal joint completely down onto the stub shaft, rotate the steering wheel slightly while pushing
down on the universal joint.
