Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
2. Fasten the strut assembly to the spring compressor KM-329-A. Make sure the hooks are seated on the strut spring properly.
3. Compress the front spring with the spring compressor KM-329-A.
4. Remove the dust cover from the bearing assembly.
5. Use an open end wrench to hold the threaded piston rod while removing the piston rod nut and the washer with a commercially available double
ring spanner, sharply offset.
Important: Record the position of the front spring locator relative to the strut assembly-to-knuckle bracket. Place the front spring locator back in the
same position during assembly.
