Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
1. Install the seal onto the axle shaft.
2. Spread the snap ring using the snap ring pliers J-8059 and install the outer joint onto the axle shaft.
3. Fill the joint seal with 175 to 195 9 (6.2 to 6.9 ounces) of the recommended grease. Repack the joint with 175 to 195 9 (6.2 to 6.9 ounces) of the
recommended grease.
4. Install a new large seal retaining clamp and a new small seal retaining clamp.
5. Crimp the new small seal retaining clamp and the new large seal retaining clamp using the seal clamp pliers J-35566.
6. Install the drive axle shaft to the vehicle.
INNER TRIPOT SEAL
-
Tools Required
-
J-8059 Snap Ring Pliers
Removal Procedure