Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Front Door Exterior Handle: Service and Repair
Removal Procedure
1. Remove the door seal trim. Refer to "Door Seal Trim".
2. Disconnect the outside door handle and the lock rods.
3. Remove the bolts and the door handle.
Installation Procedure
1. Connect the outside door handle and the lock rods.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the door handle with the bolts.
Tighten
Tighten the outside door handle bolts to 4 N.m (35 lb-in).
3. Install the door seal trim. Refer to "Door Seal Trim".
