Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Rear Door Window Glass: Service and Repair
Removal Procedure
1. Remove the door seal trim. Refer to Doors.
2. Remove the exterior B-pillar molding. Refer to Exterior Trim
3. Remove the screws that secure the glass to the window regulator.
4. Remove the glass from the door.
Installation Procedure
1. Install the glass in the door and position the glass within the window regulator.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the glass screws.
Tighten
Tighten the glass screws to 3.5 N.m (31 lb-in).
3. Install the exterior B-pillar molding. Refer to Exterior Trim.
4. Install the door seal trim. Refer to Doors.
