Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Install the front wheel speed sensor to the steering knuckle. Secure it with the bolt.
Tighten the front wheel speed sensor bolt to 9 Nm (80 inch lbs.).
2. Feed the sensor harness into the engine compartment, insert it into the grommet, and secure the grommet into the hole in the strut tower.
3. Secure the harness into the grommet holders and the clamps under the fender.
4. Install the wheel.
5. Lower the vehicle.
6. Connect the front wheel speed sensor electrical connector.
7. Connect the negative battery cable.
Wheel Speed Sensor Jumper Harness
Removal Procedure
