Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Connect the speed sensor cable from the harness.
2. Secure the harness cover and the connector to the suspension arm with a new cable tie.
3. Install the rear wheel speed sensor to the rear knuckle. Secure it with the bolt.
Tighten the rear wheel speed sensor bolt to 9 Nm (80 inch lbs.).
4. Lower the vehicle.
5. Connect the negative battery cable.
Wheel Speed Sensor Jumper Harness
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and suitably the vehicle.
3. Clip the cable ties holding the sensor connector to the forward suspension arms and remove the harness covers.
