Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Place the exhaust tail pipe trim ring, (if equipped), on the rear muffler pipe.
2. Secure the exhaust pipe trim ring on the rear muffler pipe, and tighten the exhaust trim ring bolt until it bottoms out on the exhaust pipe. Tighten
an additional quarter turn.
3. Secure the rear muffler assembly to the rear rubber hangers near the exhaust tail pipe and near the junction of the rear muffler pipe with the front
muffler pipe.
4. Place the rear muffler pipe into the front muffler pipe.
5. Secure the rear muffler pipe to the front muffler pipe with the holding clamp, the washer, and the nut.
-
Tighten the front muffler pipe-to-rear muffler pipe holding clamp nut to 50 Nm (37 ft. lbs.).