Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Blower Motor: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the glove box.
3. Remove the footwell upper cover.
4. Disconnect the blower motor electrical connector.
5. Remove the blower motor cooling hose.
6. Remove the screws that secure the motor to the heater/air distributor case.
7. Remove the motor, the seal, and the shock mount pads from the heater/air distributor case by gently pulling the motor straight down and out.
Installation Procedure
1. Install the blower motor and the seal with the shock mount pads in the heater/air distributor case. Hold the blower motor in position.
2. Install the screws to secure the blower motor to the heater/air distributor case.
Tighten
Tighten the blower motor retaining screws to 6 N.m (53 lb-in).
3. Install the blower motor cooling hose.
4. Connect the blower motor electrical connector.
5. Connect the negative battery cable.
6. Confirm that the blower motor operates properly.
7. Replace the footwell upper cover.
8. Replace the glove box.