Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Cabin Temperature Sensor / Switch: Service and Repair
In-Car Temperature Sensor
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the automatic temperature control assembly. Refer to "Automatic Temperature Control Assembly".
3. Remove the screws securing the in-car temperature sensor.
4. Disconnect the electrical connector and remove the sponge cover.
5. Remove the in-car temperature sensor from the controller.
Installation Procedure
1. Install the in-car temperature sensor into the controller.
2. Install the sponge cover and connect the electrical connector.
3. Install the in-car sensor retaining screws and tighten.
4. Install the automatic temperature control assembly. Refer to "Automatic Temperature Control Assembly".
5. Connect the battery negative cable.
