Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Install the bulb into the holder and turn the bulb to the right.
2. Install the control assembly case halves.
-
Pass the connector for the vacuum switch through the hole in the rear assembly case part.
-
Be sure to align the flats on mating control shafts of the two case halves.
3. Install the connector into the vacuum control switch.
4. Install the control assembly. Refer to "Control Assembly".
5. Connect the negative battery cable.
6. Check the knob light for proper operation.
