Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Temperature Sensor (Gauge): Service and Repair
ENGINE COOLANT TEMPERATURE SENSOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Drain the coolant to a level below the engine coolant temperature sensor.
3. Disconnect the electrical connector from the engine coolant temperature sensor.
4. Remove the temperature sensor from the exhaust gas recirculation (EGR) valve mounting adapter.
Installation Procedure
1. Install the engine coolant temperature sensor into the threaded hole in the EGR valve mounting adapter.
-
Tighten the engine coolant temperature sensor (2.0L DOHC) to 10 Nm (89 inch lbs.).
2. Connect the electrical connector to the engine coolant temperature sensor.
3. Refill the engine cooling system.
4. Connect the negative battery cable.