Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
EGR Valve: Description and Operation
The Exhaust Gas Recirculation (EGR) system is used on engines equipped with an automatic transaxle to lower NOx (oxides of nitrogen) emission levels
caused by high combustion temperature. The EGR valve is controlled by the powertrain control module (PCM)/engine control module (ECM). The EGR
valve feeds small amounts of exhaust gas into the intake manifold to decrease combustion temperature. The amount of exhaust gas recirculated is
controlled by variations in vacuum and exhaust back pressure. If too much exhaust gas enters, combustion will not take place. For this reason, very little
exhaust gas is allowed to pass through the valve, especially at idle.
The EGR valve is usually open under the following conditions:
-
Warm engine operation.
-
Above idle speed.
Results of Incorrect Operation
Too much EGR flow tends to weaken combustion, causing the engine to run roughly or to stop. With too much EGR flow at idle, cruise, or cold
operation, any of the following conditions may occur:
-
The engine stops after a cold start.
-
The engine stops at idle after deceleration.
-
The vehicle surges during cruise.
-
Rough idle.
If the EGR valve stays open all the time, the engine may not idle. Too little or no EGR flow allows combustion temperatures to get too high during
acceleration and load conditions. This could cause the following conditions:
-
Spark knock (detonation).
-
Engine overheating.
-
Emission test failure.
