Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Clutch Switch: Adjustments
Adjustment Procedure
After the clutch pedal position switch is installed, adjust it in the following manner:
1. Confirm that the engine starts when the clutch pedal is fully pressed down.
2. If the engine does not start when the clutch pedal is fully pressed down, turn the clutch pedal position switch adjusting screw until the clutch pedal
position switch is engaged so that the engine will start. Do not adjust the screw so far down that it damages the clutch pedal position switch.
3. Confirm that the engine does not start when the clutch pedal is released.
4. If the engine starts when the clutch pedal is released completely, replace the clutch pedal position switch.