Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Disconnect the negative battery cable.
2. Disconnect connector from the EBCM.
3. Remove the appropriate terminals from connector:
-
Right-side - terminals 3 (PRL) and 5 (YEL).
-
Left-side - terminals 6 (WHT) and 7 (ORN).
4. Both speed sensor harnesses break out of the ABS wiring harness just beyond the ABS connector. The right-side speed sensor harness crosses the
top of the fire wall to the right-side fender area. The left-side speed sensor harness goes directly to the left-side fender area.
5. Free the speed sensor harness from the wiring harness.
6. Remove the front wheel speed sensor electrical connector from the retaining clamps and disconnect the harness from the sensor connector.
Installation Procedure
1. Install the front wheel speed sensor jumper harness.
2. Connect the front wheel speed sensor electrical connector and secure it into the clamps.
