Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
1. Insert the CKP sensor into the engine block.
2. Install the CKP sensor retaining bolt.
Tighten
Tighten the crankshaft position sensor retaining bolt to 58 lb-in (6.5 N.m).
3. Connect the CKP sensor connector to the fuel injector channel cover.
4. Install the accessory mounting bracket.
Tighten
Tighten the accessory mounting bracket bolts to 37 N.m (27 lb-ft).
5. Install the rear A/C mounting bracket, if equipped.
Tighten
Tighten the rear A/C mounting bracket bolts to 26 lb-ft (35 N.m).
6. Install the A/C compressor, if equipped. Refer to Manual Control Heating, Ventilation, and Air Conditioning System.
7. Install the power steering pump, if equipped. Refer to Power Steering Pump.
8. Connect the negative battery cable.