Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
9. Connect the power steering gear fluid inlet pipe.
Tighten the steering gear inlet pipe fitting to 28 Nm (21 ft. lbs.).
10. Connect the power steering gear fluid outlet pipe.
Tighten the steering gear outlet pipe fitting to 28 Nm (21 ft. lbs.).
11. Do a straight-ahead check.
Notice: When adding fluid or making a complete fluid change, always use power steering fluid DEXRON-III or equivalent. Failure to use the
proper fluid will cause hose and seal damage and fluid leaks.
12. Refill the power steering system and check for leaks. If leaks are found, correct the cause of the leak and bleed the system.
13. Connect the negative battery cable.
Disassembly and Reassembly
RACK AND PINION
-
Tools Required
-
KM-J-22610 Installer
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.
