Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
4. Connect the power steering gear hydraulic cylinder pipes to the power steering gear at the cylinder end and clip them to the power steering fluid
reservoir return line.
Tighten the hydraulic cylinder line fittings at the cylinder end to 27 Nm (20 ft. lbs.).
5. Lower the vehicle.
Notice: When adding fluid or making a complete change, always use DEXRON-III power steering fluid. Failure to use the proper fluid will cause
hose and seal damage and fluid leaks.
6. Fill the fluid reservoir with power steering fluid.
7. Inspect for leaks. If there are leaks, correct the cause of the leaks and bleed the system.
Stub Shaft Seals and Upper and Lower Bearing
STUB SHAFT SEALS AND UPPER AND LOWER BEARING
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.
2. Remove the dust cover from the lower end of the housing.
Notice: If the stub shaft is not held, damage to the pinion teeth will occur.
