Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Fluid - A/T: Testing and Inspection
TRANSAXLE FLUID LEVEL CHECKING PROCEDURE
1. Start the engine and allow the engine to idle for approximately 5 minutes, or, if possible, drive the vehicle for a few miles to warm the transaxle
fluid.
Check the fluid level when the transaxle is above 104° F (40° C).
2. Park the vehicle on a hoist, inspection pit, or similar raised-level surface. The vehicle must be level to obtain a correct fluid level measurement.
3. Place a fluid container below the fluid level plug.
4. Press the brake pedal and move the shift lever through the gear ranges, pausing a few seconds in each range. Return the shift lever to PARK.
