Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
7. Remove the shaft-retaining ring using the snap ring pliers J-8059.
8. Remove the tripot and the tripot joint retaining ring from the axle shaft.
9. Remove the tripot joint seal from the axle shaft.
Installation Procedure
-
Tools Required
-
J-35566 Seal Clamp Pliers
1. Install a new small seal-retaining clamp onto the seal.
Do not crimp the seal-retaining clamp.
2. Install the seal onto the axle shaft.
3. Install the tripot joint retaining ring and the tripot onto the axle shaft.