Nubira SX Wagon L4-2.0L DOHC D-TEC MFI (1999)
Daytime Running Lamp Control Unit: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the HVAC controls.
3. Remove the screws and the daytime running lamp module.
4. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
2. Install the daytime running lamp module with the screws
Tighten
Tighten the daytime running lamp module screws to 4 Nm (35 lb.in).
3. Install the HVAC controls.
4. Connect the negative battery cable.