Charade L3-0993cc 1.0L (1988)
Pulley And Bolt
(d) Loosen the attaching bolt of the idler pulley. Apply tension to the timing belt by means of the tension spring. Then, temporarily tighten the
attaching bolt again.
Crank Bolt
(e) Screw in the crankshaft pulley bolt to the crankshaft. Turn the crankshaft two turns and stop it when the piston No.1 reaches the top dead
center. During this operation, never turn the crankshaft in reverse.
If the crankshaft is reversed, turn the crankshaft two turns again. Then, stop the crankshaft when the piston No.1 reaches the top dead center.
NOTE: When the "F" mark comes just at the top position, the piston No.1 is also at the top dead center.
Idler Pulley And Bolt
(f) Loosen the attaching bolt of the idler pulley. Apply tension to the timing belt by means of the tension spring. Tighten the attaching bolt again.
Tightening Torque:
3.0 - 4.5 kg-m (24.6 - 32.5 ft-lb., 33.3 - 44.1 Nm)
