Charade L4-1295cc 1.3L (1989)
Installing Crank Gear Bolt
5.
Install the set bolt of the crankshaft timing belt pulley.
Removing Crank Bolt
6.
Prevent the crankshaft from being rotated by placing the gear shift lever in the 4th gear position in the case of the manual transmission vehicle; by
inserting a screwdriver or the like into the ring gear at the rear end section of the cylinder block in the case of the automatic transmission vehicle.
Then, tighten the set bolt of the crankshaft timing belt pulley.
Tightening Torque:
9.0 - 10.0 kg-m (65.1 - 72.0 ft-lb, 88.3 - 98.0 Nm)
CAUTION:
^
It should be noted that the specified torque can not be attained easily due to a slight turning of the crankshaft during the tightening.
^
Never allow the crankshaft to turn.
Cam Pulley
7.
Install the camshaft timing belt pulley on the camshaft in such a way that the "F" mark can be seen and the locating pin hole is aligned. Then,
install the set bolt.
NOTE: Remove any oil or water from the camshaft timing belt pulley. Keep the pulley clean.
