1500 4x2 Pickup V8-5.2L CNG VIN T (1996)
Throttle Position Sensor: Testing and Inspection
Component Test
Fig. 40 Sensor And IAC Location - Typical
The Throttle Position Sensor (TPS) can be tested with a digital voltmeter. The center terminal of the TPS is the output terminal.
With the ignition key in the ON position, check the TPS output voltage at the center terminal wire of the connector. Check this at idle (throttle plate
closed) and at wide open throttle (WOT). At idle, TPS output voltage should must be greater than 200 millivolts. At wide open throttle, TPS output
voltage must be less than 4.8 volts. The output voltage should increase gradually as the throttle plate is slowly opened from idle to WOT.
NOTE: For additional testing information and circuit diagnosis see Testing and Inspection/Test TC-26A or TC-27A