1500 4x2 Pickup V8-5.2L CNG VIN T (1996)
4. Using a rocking motion, separate the fuel injectors and fuel rail from the intake manifold and discard all the old "O" rings.
5. Remove the fuel injectors from the fuel rail and discard all the old "O" rings.
INSTALLATION
1. Install new O-ring seals on the top of each injector, before installation lightly lube each O-ring with clean motor oil.
2. Install each injector into its position on the fuel rail, and install the retainer clips.
3. Install a new O-ring onto the exposed end of each fuel injector, lightly lube each O-ring with clean motor oil.
4. Install the fuel injectors and fuel rail into the intake manifold and tighten fuel rail mounting bolts to 20 ft-lbs (27 Nm).
5. Reassemble Intake Manifold & Throttle Body as described in Fuel Rail/Service and Repair.
6. Connect the negative battery cable, and Install the fuel tank filler cap.
7. Connect the DRB II scan tool and select the Automatic Shut Down (ASD) Fuel System Test to pressurize fuel system and check for leaks.
CAUTION: Unless the test is stopped or the ignition switch is turned to the OFF position the fuel pump relay and the ASD relay will remain
energized for 7 minutes by the ASD Fuel System Test.
