1500 4x2 Pickup V8-5.2L CNG VIN T (1996)
14.
Place the ignition switch against the lock housing opening on the steering column. Ensure that the ignition switch park lock dowel pin enters the
slot in the park lock slider linkage in the steering column.
15.
Install the ignition switch screws (Figure 8). Tighten the screws to 26 in-lbs (3 Nm).
16.
Connect the key-in/halo light electrical connector to the new ignition switch (Figure 7).
NOTE:
DO NOT connect the 7-way ignition switch connector.
D. Install Blower Motor Relay and Overlay Harness
1.
Remove the 30-amp fuse from the fuseblock F2 -- Blower Motor location (Figure 13).
2.
Remove the TAN wedge from the fuseblock (Figure 13).
3.
Remove the BLACK with ORANGE tracer (A22) wire from cavity 11 of the fuseblock (Figure 13); then cut the terminal off and tape the wire
back to the harness.
4.
Remove the DARK GREEN (C1) wire from cavity 12 of the fuseblock (Figure 13).
5.
Disconnect the 84-way bulkhead connector.
6.
Remove the cover from the rear of the 84-way connector.
7.
Remove the BLUE wedge from the 84-way connector.
