2500 4x2 Pickup L6-359 5.9L DSL Turbo (1994)
CAUTION: The seal lip and the sealing surface on the crankshaft must be free from all oil residue to prevent seal leaks.
The crankshaft and seal must be dry when the seal is installed.
Install the seal pilot, provided in the replacement kit, on the crankshaft. Push the seal on the pilot and crankshaft.
Remove the seal pilot.
NOTE: Seal O.D. lubricant/sealant:
^
Rubber O.D. rear crankshaft seals are lubricated with soapy water.
^
Seals without rubber O.D. use Loctite 277, 11264 or no. 2854422 sealant.
Use the alignment tool to install the seal to the correct depth in the housing. Use a hammer to drive the seal into the housing until the alignment
tool stops against the housing.
Hit the tool at the 12, 3, 6 and 9 o'clock positions to drive the seal evenly and prevent bending the seal housing.
