2500 4x2 Pickup V10-488 8.0L Magnum (1996)
8.
Remove bushing from passenger side of pedal (Figure 1).
9.
Lubricate shaft bores in bracket and pedal with Mopar Multi-mileage Lube (P/N 4318063).
10.
Install wave washer (P/N 52009582) onto bushing, then install bushing back into pedal.
NOTE:
THE BRAKE PEDAL SHOULD HAVE TWO BUSHINGS (ONE ON EACH END OF THE SHAFT BORE). REPLACE ALL DAMAGED OR
MISSING BUSHINGS WITH BUSHING P/N 4294639.
11.
Apply liberal quantity of Mopar Multi-mileage Lube to pedal shaft and to pedal bushings.
12.
Position brake pedal in mounting bracket.
13.
From passenger side, slide pedal shaft into bracket and through pedal.
14.
Push pedal shaft out driver side of mounting bracket just enough to allow installation of retaining E-clip.
15.
Install booster push rod on brake pedal. Secure push rod to pedal with washer and retaining clip.
16.
Install stop lamp switch.
17.
Install knee bolster.
18.
Install stop lamp fuse.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
05-50-01-92
0.5 Hrs.
FAILURE CODE:
XX - Service Adjustment
