2500 4x2 Pickup V10-488 8.0L Magnum (1996)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Rear Antilock Valve Replacement
REMOVAL
1. Disconnect ground wire and harness at rear anti-lock and combination valve, then disconnect front and rear hydraulic brake lines from valve.
2. Remove brake lines between master cylinder and combination valve, then remove nuts securing master cylinder and combination valve to power
booster.
3. Remove master cylinder, then remove combination valve, rear anti-lock valve and bracket as an assembly.
4. If necessary, separate bracket from valves.
INSTALLATION
1. Reverse procedure to install, noting the following:
a. Do not tighten component mounting bolts fully until hydraulic line fittings have been threaded into their bores. This will prevent
cross-threading of fittings.
b. Torque hydraulic line fittings to 12-16 ft. lbs.
c. Torque rear anti-lock valve mounting bolt to 16-25 ft. lbs.
d. Bleed brake system as described under Antilock Brake System/Service and Repair.
