2500 4x2 Pickup V10-488 8.0L Magnum (1996)
a. Turn the ignition switch to the ON position.
b. Turn the blower motor on LOW and verify that the blower is operating.
c. Disconnect the relay.
^
If the blower motor stops, this relay is for the blower motor.
^
If the blower motor does not stop, this relay is NOT for the blower motor.
d. Turn the ignition switch OFF and connect the relay.
4.
^
If a blower motor relay is NOT present, continue with Section "B - Inspect Ignition Switch and Wiring."
^
If a blower motor relay is present, no further action is necessary. Return the vehicle to the customer.
B. Inspect Ignition Switch and Wiring
1.
Disconnect the negative battery cable(s).
NOTE:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
2.
Remove the five (5) screws that secure the knee blocker to the lower instrument panel and then remove the knee blocker (Figure 3).
3.
Remove the steering column tilt lever by turning it counter-clockwise.
