2500 4x2 Pickup V10-488 8.0L Magnum (1996)
7.
Remove the key cylinder from the ignition switch (Figure 10).
8.
Place the new ignition switch in the LOCK position. The switch is in the LOCK position when the column lock flag is parallel to the ignition
switch terminals (Figure 11).
9.
With the key cylinder in the LOCK position, insert the key cylinder into the new ignition switch until it bottoms.
10.
Insert the ignition key into the key cylinder. While gently pushing the key cylinder in toward the ignition switch, rotate the ignition key clockwise
to the end of travel (START position) and then back to the LOCK position.
11.
If equipped, install the key cylinder retaining bracket and screw (Figure 9). Tighten the screw to 26 in-lbs (3 Nm).
12.
Apply a light coating of grease to the ignition switch column lock flag and the park lock dowel pin (Figure 11).
13.
Make sure that the transmission gear shift selector is in the PARK position. The park lock dowel pin must be properly indexed before installing the
ignition switch (Figure 12).
