2500 4x2 Pickup V10-488 8.0L Magnum (1996)
29.
Disconnect the ground eyelet near the airbag squib connector (Figure 17).
30.
Double stack the ground eyelet on the BLACK blower relay harness wire onto the ground screw. Install the ground screw and tighten securely.
31.
Attach the blower relay onto one of the horizontal relay mounting tabs on the bracket located on the brake pedal support just above the brake lamp
switch and pedal (Figure 18).
NOTE:
For early 1994 model year vehicles that do not have a relay bracket or if two relays are already attached to the bracket, secure the relay to the wiring
harness with a tie strap.
32.
Re-tape all of the portions of the ignition switch wiring harness from which tape was removed.
33.
Position the ignition switch wires back inside of the wiring trough.
34.
Snap the steering column wiring trough back on to the steering column using the supplied clips as necessary.
35.
Connect the 7-way ignition switch electrical connector.
36.
Install the lower steering column shroud (Figure 4).
37.
Install the upper and lower steering column covers (Figure 4).
38.
Install the steering column tilt lever (Figure 4).
39.
Install the knee blocker and tighten the screws securely (Figure 3).
40.
Connect the negative battery cable(s).
