2500 4x2 Pickup V8-318 5.2L Magnum (1994)
Fig. 24 Location of Front Antilock Valve Bleed Valve Stem and Plug
b. Remove cap from bleed valve stem.
Fig. 25 Front Antilock Valve Bleed Tool Installation
c. Install Valve Depressor Tool 6670 on bleed valve stem. To install tool, slide notched side of tool onto boss that surrounds bleed valve stem.
Stem must be held inward (in open position) to flilly bleed upper section of new valve assembly.
d. Tighten thumbscrew on bleed Tool 6670 just enough to push valve stem inward about 0.51 - 0.76 mm (0.020 - 0.030 in.).
e. Apply brake pedal. Pedal will fall off significantly when bleed plug is properly open and bleed valve stem is correctly unseated (pressed
inward) by tool.
f.
Stroke brake pedal rapidly 5 - 10 times. This action will fill upper and lower sections of valve rapidly.
g. Bleed new valve assembly at each brakeline fitting one at a time. Remember to close valve bleed plug before each brake pedal stroke.
Continue bleeding until fluid flowing from fittings is clear and free of bubbles.
h. Remove depressor tool from valve stem and install cap on stem. Then tighten bleed plug to 7 - 9 Nm (60 - 84 in. lbs.) torque.
8. If original front antilock valve assembly is still in place, bleed plug and bleed valve do not have to be open during bleeding operations.
Just bleed the valve assembly at each brakeline fitting one at a time.
9. Bleed wheel brake units one at a time in recommended sequence and as follows.
