2500 4x2 Pickup V8-318 5.2L Magnum (1994)
Electronic Brake Control Module: Service and Repair
With Four Wheel Antilock System
Fig. 25 Main Harness Connector
NOTE: The ABS module is located in the engine compartment attached to the forward side of the front brake anti-lock valve.
1. Disconnect upper harness connector from module.
2. Lift connector locking handle to release main harness connector for module. Rotate handle upward to clear connector.
3. Lift connector up and out of retaining lugs on module.
4. Remove module mounting screws then the module.
5. Reverse procedure to install, installing harness main connector as follows:
a. Connecting main harness connector to module.
b. Seat connector in module retaining lugs and start connector into module.
c. Rotate connector locking handle downward into position to seat and retain connector.
