2500 4x2 Pickup V8-318 5.2L Magnum (1994)
REMOVAL AND INSTALLATION
WARNING:
This system is a sensitive, complex electro-mechanical unit. Before attempting to diagnose, remove or install the airbag system or related
steering wheel and steering column components you must first disconnect and isolate the battery negative (ground) cable. Then wait two
minutes for the system capacitor to discharge before further system service. This is the only sure way to disable the airbag system. Failure
to do this could result in accidental airbag system deployment and possible personal injury.
When removing a deployed airbag module, rubber gloves, eye protection, and a long-sleeved shirt should be worn. There may be deposits
on the airbag module and other interior surfaces. In large doses these deposits may cause irritation to the skin and eyes.
1. Disconnect and isolate the battery negative cable. If the airbag module is undeployed, wait two minutes for the system capacitor to discharge
before further service.
2. From the underside of the steering wheel remove the speed control switch or trim bar mounting screws.
Fig 6 Speed Control Switch Connector Remove/Install
3. Pull the switches or trim bar from the steering wheel. If equipped with speed control, unplug the wiring connector from the switch.
Right Rear Steering Wheel Cover Remove/Install
4. Using a small screwdriver remove right rear steering wheel cover.
