2500 4x2 Pickup V8-318 5.2L Magnum (1994)
CAUTION: Do not turn stub shaft any further than necessary. The rack piston balls will drop out of the rack piston circuit if the stub shaft is
turned too far.
3. Remove O-ring from the housing.
ASSEMBLY
1. Lubricate O-ring with power steering fluid and install into the housing.
2. Install end plug by tapping the plug lightly with a plastic mallet into the housing.
3. Install retaining ring so one end of the ring covers the housing access hole.
Pitman Shaft/Seals/Bearing
The content of this article reflects changes called for in TSB 26-01-97.
DISASSEMBLY
1. Clean exposed end of pitman shaft and housing with a wire brush.
