2500 4x2 Pickup V8-5.9L VIN Z (1994)
Do not hammer or jolt steering column or shaft during removal of wheel.
12.
Remove the four steering wheel back cover attaching screws. Remove the back cover from the steering wheel and discard (Figure 6).
13.
Install the provided back cover using the original screws.
14.
Carefully route the airbag and speed control (if equipped) wires through the lower hole in the steering wheel. Route the horn wire through the
smaller hole at the top (Figure 7). Ensure that the wires are not pinched or damaged.
15.
Install the steering wheel with the master splines aligned.
16.
Install the retaining nut and torque to 45 ft lbs. (61 Nm).
IMPORTANT:
Press and seat the steering wheel on the shaft using the retaining nut only. Do not hammer or jolt the column or shaft to install the wheel.
17.
Connect the wire to the horn buttons.
18.
Connect the squib wiring connector to the air bag module by pressing straight in on the connector. The connector should latch securely beneath the
module locking clip to assure a positive connection.
19.
Install the air bag module. Install the four attaching nuts and torque to 90 in-lbs (10 Nm).
