2500 4x4 Pickup L6-359 5.9L DSL Turbo (1995)
Side Cover: All Technical Service Bulletins
Draft Tube - Excessive Oil Drainage
NO: 09-04-95
GROUP: Engine
DATE: Apr. 14, 1995
SUBJECT:
Excessive Oil Drainage from Draft Tube
MODELS:
1994-1995 (BR) Ram Truck
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 5.9L DIESEL ENGINE BUILT PRIOR TO 12/1/94 (MDH 12-01-XX).
SYMPTOM/CONDITION:
Excessive oil drainage from the draft tube.
PARTS REQUIRED:
1
4798939
Sealed Tappet Cover
1
4798940
Tappet Cover Gasket
6
4429267
Rubber Grommet Seals
REPAIR PROCEDURE:
This bulletin involves replacing the current tappet cover with a new sealed tappet cover.
1.
Disconnect the negative battery cable at both batteries.
2.
Remove the fuel injection pump.
3.
Remove the tappet cover and gasket. Remove the grommet seals from the capscrews and discard.
New Tappet Cover With Drain
4.
Install the new tappet cover gasket. This gasket must be installed as shown in Figure 1.
5.
Install the new tappet cover with the mounting capscrews and rubber grommet seals. If the application requires a fuel drain line to be installed, use
the # 2 and # 6 capscrews. The capscrews should be torqued in the following sequence 4, 3, 5, 2, 6, and 1 to 24 Nm (18 ft.lbs.). Torque from the
inner most capscrews to the outer most.
6.
Check to be sure breather tube is free of all debris and oil.
7.
Install the fuel injection pump.
8.
Connect the negative battery cable at both batteries.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE: