2500 4x4 Pickup L6-359 5.9L DSL Turbo (1995)
Fuel Supply Line: Service and Repair
Low Pressure Fuel Line - Replacement
Remove the line from the lift pump and filter head.
CAUTION: When replacing fuel lines, replace banjo fitting sealing washers (1) each time they are removed.
Install the line and tighten the fittings securely.
Banjo fitting Torque Value: 24 N-m [18 ft-lbs]
Bleed the line by opening the banjo bleed screw.
Bleed the air from the system.
Operate the hand lever until the fuel flowing from the fitting is free of air. Tighten the bleed screw.
Torque Value: 8 N-m [6 ft-lbs].
NOTE: If the lever feels as though it is not pumping, rotate the engine approximately 90 degrees and proceed.
CAUTION: The hand priming lever must be returned to the lock position after priming. The lever will be in the up position when locked.
