2500 4x4 Pickup V8-318 5.2L Magnum (1995)
Generator: Reading and Clearing Diagnostic Trouble Codes
Displaying & Reading Trouble Codes
CHECK ENGINE LAMP
To start the function, cycle ignition switch ON-OFF-ON-OFF-ON within 5 seconds and any stored fault code will appear. Check engine lamp will
display the code by flashing on and off. There is a short pause between flashes and a longer pause between digits. All codes displayed are 2 digit
numbers with a 4 second pause between codes. The lamp will flash until all codes are displayed then 55 (end test) will appear.
SCAN TOOL
1. On 1994-95 models, connect DRB test tool or equivalent scan tool, to Diagnostic Link Connector (DCL) located under the hood.
2. On 1996 models, connect DRB test tool or equivalent scan tool, to DCL located under the instrument panel.
3. On all models, follow scan tool manufactures instructions to access Diagnostic Trouble Codes (DTCs).
Clearing Diagnostic Trouble Codes
Diagnostic Trouble Codes (DTCs) may only be cleared with the use of a suitable scan tool.
Follow scan tool manufacturers instructions to clear DTCs.
