3500 4x2 Pickup V10-488 8.0L Magnum (1996)
Manifold Pressure/Vacuum Sensor: Service and Repair
NOTE: A rubber gasket is used to seal the sensor to the intake manifold. The rubber gasket is part of the sensor and is not serviced separately
Fig. 16 MAP Sensor Location - Typical
REMOVAL
1. Remove the electrical connector at the sensor.
2. Clean the area around the sensor before removal.
3. Remove the two sensor mounting bolts.
4. Remove the sensor from the intake manifold.
INSTALLATION
1. Check the condition of the sensor seal. Clean the sensor and lubricate the rubber gasket with clean engine oil.
2. Clean the sensor opening in the intake manifold.
3. Install the sensor into the intake manifold.
4. Install sensor mounting bolts. Tighten bolts to 2 N.m (20 in. lbs.) torque.
5. Install the electrical connector to sensor.