3500 4x2 Pickup V8-360 5.9L Magnum (1994)
Console: Service and Repair
CENTER SEAT/CONSOLE REMOVAL
1. Remove bolts on driver and passenger seat inboard seat tracks.
2. Separate center section.
INSTALLATION
1. Position and align center section on driver and passenger seat inboard seat tracks.
2. Install bolts. Tighten to 19.5 Nm (14 ft. lbs.) torque.
CONSOLE LID REMOVAL
1. Open console lid.
2. Using a small flat blade screwdriver, disengage locking tabs located under the console lid trim bezel.
3. Separate bezel from lid.
4. Move driver and passenger seat to full forward position.
5. Using a small drift and hammer, tap out console lid hinge pin.
6. Separate lid from console.
INSTALLATION
1. Align console lid with console. Verify lid tension spring is in position.
2. Install hinge pin.
3. Position trim bezel on lid and snap into place.
Rear Floor Stowage Tray
REAR FLOOR STOWAGE TRAY REMOVAL
1. Move seat tracks to forward position.
2. Remove screws holding rear floor stowage tray to floor.
3. Disengage hooks on stowage tray from slots in rear closure panel trim.
4. Separate rear floor stowage tray from vehicle.
5. Reverse the preceding operation for installation.
