3500 4x2 Pickup V8-360 5.9L Magnum (1994)
Stabilizer Link: All Technical Service Bulletins
Stabilizer Bar/Link - Rattling/Clunk Noise
NO: 02-05-95
GROUP: Suspension
DATE: May 15, 1995
SUBJECT:
Rattling/Clunk Type Noise from Front of Vehicle
MODELS:
1994-1995 (BR) Ram Truck
Note
THIS BULLETIN APPLIES TO 1994 VEHICLES EQUIPPED WITH 4X4 AND 4X2 CAB CHASSIS, AND 1995 VEHICLES EQUIPPED WITH
4X4 AND 4X2 CAB CHASSIS BUILT WITHOUT TAPERED BALL STUD LINKS THAT ARE ATTACHED TO THE STABILIZER BAR
WITH A CASTLE NUT AND COTTER PIN.
SYMPTOM/CONDITION:
Rattling or clunk type noise from front of vehicle.
DIAGNOSIS:
Verify that the ball stud link is the straight type and then proceed with the repair
procedure. If vehicle is equipped with the ball stud links, it has the most current
components and the bulletin does not apply.
PARTS REQUIRED:
2
52038665
Link
2
6502748
Castle Nut
2
6100017
Cotter Pins
1
52038924
Stabilizer Bar 6400 + 7500 GVW 4x4
1
52038925
Stabilizer Bar 8800 + 10,500 GVW 4x4 and 4x2,4x4 Cab Chassis
REPAIR PROCEDURE:
This bulletin involves replacement of both stabilizer links with tapered ball stud links, along with the replacement of the stabilizer bar with one with
tapered holes.
1.
Raise and support the vehicle.
2.
Disconnect the stabilizer bar links from the axle brackets.
3.
Disconnect the stabilizer bar from the links.
4.
Disconnect the stabilizer bar clamps from the frame rails and remove the stabilizer bar. Discard or return as required the old stabilizer bar and
links.
5.
Position the new stabilizer bar on the frame rail and install clamps and bolts. Ensure the bar is centered with equal spacing on both sides. Tighten
the bolts to 47 Nm (35 ft. lbs.).